Update the Firmware of LiteBee Wing

From Makerfire
Jump to: navigation, search

Guide for Firmware updating

Attention！
a.The drone’s firmware version V105 only works when with the V1.0.7 firmware controller and the programming software - LiteBeego v0.95
b. The drone’s firmware version V108 only works when with the V1.1.0 firmware controller and the programming software - LiteBeego v1.1.3

1.Introduction
This file aims to tell how to update the firmware of the drone.

  • 1.1Install the driver


Take the battery out from the drone, press the reset button (as the picture shows) with a needle, hold until the drone connected with the computer through a USB wire, and its light on.

Reset.png


Right-click “This PC” and then follow the path “manage” - “Device Manager” - “Other devices” to find the “Unknown device”

Path1.png

Right-click the “Unknown device”, - choose “Update driver”, - choose “browse my computer for driver software” - find the downloaded file, follow the path “LiteBee Wing update/Firmware update/Driver software/” - choose “usbdriver” - click “Next” to update.
If update successfully, this device(USB device (VID_***_PID_***)) will be shown in the file of “Universal Serial Bus controllers”. After the updating, disconnect the drone and computer.

Driver.png

  • 1.2Update the firmware


Open the downloaded file, follow the path “LiteBee Wing update/Firmware update/Driver software/PhoenixUSBPro” to start the burning software. Click the “Image” to choose the firmware you want to update(path: LiteBee Wing update/Firmware update/Firmware/)

Updating.png

Press the reset button of the drone and hold until the drone connects with the computer and the “√” mark of the software became “×”. Release the button, and the update is under process automatically, when the process bar becomes 100%, the updating finished.

Updated.png

Retrieved from "http://wiki.makerfire.com/index.php?title=Update_the_Firmware_of_LiteBee_Wing&oldid=1742"