View source for Update the Firmware of LiteBee Wing

Guide for Firmware updating

Attention！
<br />a.The drone’s firmware version V105 only works when with the V1.0.7 firmware controller and the programming software - LiteBeego v0.95
<br />b. The drone’s firmware version V108 only works when with the V1.1.0 firmware controller and the programming software - LiteBeego v1.1.3

'''1.Introduction'''
<br />This file aims to tell how to update the firmware of the drone.
*1.1Install the driver
<br />Take the battery out from the drone, press the reset button (as the picture shows) with a needle, hold until the drone connected with the computer through a USB wire, and its light on.

[[File:reset.png|500px]]]


Right-click “This PC” and then follow the path “manage” - “Device Manager” - “Other devices” to find the “Unknown device”

[[File:path1.png|500px]]]

Right-click the “Unknown device”, - choose “Update driver”, - choose “browse my computer for driver software” - find the downloaded file, follow the path “LiteBee Wing update/Firmware update/Driver software/” - choose “usbdriver” - click “Next” to update. <br />If update successfully, this device(USB device (VID_***_PID_***)) will be shown in the file of “Universal Serial Bus controllers”. After the updating, disconnect the drone and computer.

[[File:driver.png|500px]]]

*1.2Update the firmware
<br />Open the downloaded file, follow the path “LiteBee Wing update/Firmware update/Driver software/PhoenixUSBPro” to start the burning software. Click the “Image” to choose the firmware you want to update(path: LiteBee Wing update/Firmware update/Firmware/)

[[File:updating.png|500px]]]

Press the reset button of the drone and hold until the drone connects with the computer and the “√” mark of the software became “×”. Release the button, and the update is under process automatically, when the process bar becomes 100%, the updating finished.

[[File:updated.png|500px]]]