Difference between revisions of "F4 WHOOP PRO Flight Control"
| Line 1: | Line 1: | ||
| − | [[File:44700.jpg]]<br><br><br> | + | [[File:44700.jpg|300px]]<br><br><br> |
F4 WHOOP PRO flight control is suitable for 1S (3.7V-4.2V lipo battery) brushless system control, internal use STM32F411 as main control with MPU6000 gesture sensor integrated video overlay OSD image display,<br> | F4 WHOOP PRO flight control is suitable for 1S (3.7V-4.2V lipo battery) brushless system control, internal use STM32F411 as main control with MPU6000 gesture sensor integrated video overlay OSD image display,<br> | ||
Latest revision as of 15:04, 31 October 2018
F4 WHOOP PRO flight control is suitable for 1S (3.7V-4.2V lipo battery) brushless system control, internal use STM32F411 as main control with MPU6000 gesture sensor integrated video overlay OSD image display,
the key highlights integrated four 5A brushless Adjust driver and FRSKY receiver in one.
Specifications:
Firmware: betaflight_3.3.0_MATEKF411RX
Betaflight target: MATEKF411RX
MCU: STM32F411CEU6
Sensor: MPU-6000(SPI connection)
Power supply: 1S battery input (DC 3.5-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Frsky receiver with telemetry D8
Built-in Betaflight OSD(SPI Controll)
Built-in 5V 0.8A BEC with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Board size: 28 * 28MM
Board weight: 2.8 g
ESC parameters:
Power supply: 1S LiPo/LiPo HV (4.2v/4.35v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_L_5_REV16_7.HEX
Motor connector: JST PH1.25 3pin
Signal Support: Dshot150/Dshot300/Dshot600/Oneshot125/Multishot/PWM
Receiver parameters:
SPI BUS receiver
Compatible Frsky D8/D16
Channels: 8ch/16CH
Failsafe support
No ground interference ( Transmitting and receiving 1 m from the ground): 300m
